你好，電動扭剪扳手使用步驟如下：
Hello, the steps to use an electric torsion wrench are as follows:
1. 準備工作：確認電動扭剪扳手是否充電，檢查配件是否齊全。
1. Preparation: Confirm whether the electric torsion wrench is charged and check if the accessories are complete.
2. 安裝剪刀頭：將剪刀頭插入電動扭剪扳手的夾口中，確保剪刀頭固定牢固。
2. Install the scissors head: Insert the scissors head into the clamp of the electric torsion wrench to ensure that the scissors head is firmly fixed.
3. 調節扭力：根據需要，調節電動扭剪扳手的扭力大小。
3. Adjusting torque: Adjust the torque of the electric shear wrench as needed.
4. 開始使用：將電動扭剪扳手的剪刀頭放置在需要剪切的材料上，按下扳手開關開始工作。剪刀頭會自動旋轉，剪斷材料。
4. Start using: Place the scissors head of the electric torsion shear wrench on the material that needs to be cut, and press the wrench switch to start working. The scissors head will automatically rotate to cut the material.
5. 結束使用：使用完畢后，將電動扭剪扳手關閉，并將剪刀頭從夾口中取出。
5. End of use: After use, close the electric shear wrench and remove the shear head from the clip.
使用注意事項：
Precautions for use:
1. 在使用前，務必確認電動扭剪扳手是否充電，并檢查配件是否齊全。
Before use, be sure to confirm whether the electric torsion wrench is charged and check if the accessories are complete.
2. 在使用過程中，保持電動扭剪扳手和剪刀頭的清潔和干燥。
2. During use, keep the electric torque wrench and scissors head clean and dry.
3. 在剪切材料時，要注意，避免手部接觸剪刀頭。
3. When cutting materials, pay attention to safety and avoid hand contact with the scissors head.
4. 在使用過程中，如果發現電動扭剪扳手有異常，應及時停止使用并聯系售后服務。
During use, if any abnormalities are found with the electric torsion wrench, it should be stopped in a timely manner and after-sales service should be contacted.
This article is dedicated by a dedicated wrench for torsion shear bolts. For more information, please click on: http://www.ykmzc.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned
